The MC-5B functions seamlessly as a single axis, stand-alone system or as a multi-axis networked system, either with or without a PC. The peer-to-peer network architecture makes it possible for every MC-5B in a multi-axis system to control every axis in the motion system. No software development or complex wiring is required. The controllers themselves may be programmed to store and recall positions and to sequence through stored positions with looping, pausing and user/program interaction. Automation may also be driven serially from a PC or host processor. FEATURES: Compatible with all NAI motorized stages Communicate to any node on the system through your PC’s Serial Port Up to 99 MC-5B controllers can be configured on a single motion system Control all nodes from any node on the motion network Original Settings are retained Configure each unit as a node on the network with a unique node number Broadcast Single or Multiple Motion Commands to one node or all nodes at the same time. BENEFITS: Instant “Out-of-the-Box” Motion Control A Low Cost, Integrated Motion Solution No need to write additional motion commands Perfect for Rapid Development, Prototyping, Bread Boarding, Proof-of-Concept, Small OEM lots where delivery is Critical Specifications MC-5B Controller: Display: Two Line, 20 character alphanumeric LCD Control: Keypad or PC Optional Accessories: Communication Kit, Remote Dial Encoder Wheel, Remote Joystick Motor Load: any 6-12 Vdc brush type motor (750 mA max) Encoder Interface: Single ended, 5 Vdc TTL compatible A/B Quadrature Encoder Input Remote Communication: RS-232 Dimensions: 132.08 x 190.5 x 63.5 mm Weight: 1.25 Kilograms Operating Temperature: 20°C (Ambient) Fuse: 2 Amp Bussman model ABC-2 (or equivalent) MC-5B Power Supply: Input Voltage: 100 to approximately 240 Vac Input Frequency: 47 to 63 Hz Input Current: 0.6 A max Output Voltage: 15 Vdc Output Current: 1.4 A Operating Temp.: 20°C (Ambient) Dimensions: 108 x 49.53 x 30.48 mm Weight: 22.7 grams Accessories: Model MC-5B Encoder Wheel Single Axis Manual Positioning Control for the MC-5B Servo Controller Manually adjust Linear or Rotary position without writing any software Just plug it in and you are ready for precision positioning Each “click” of the Encoder Wheel generates motion in increments that you define Easy to use remote control Large Velcro base for easy, stable surface placement Package includes all required cabling Model MC-5B Joystick Single or Dual Axis Manual Positioning Control for the MC-5B Servo Controller. Manually adjust Linear or Rotary position without writing any software Just plug it in and you are ready for precision positioning Integrated 2-Speed Control; Standard Jog and Accelerated Jog Integrated Dual Axis Positioning System can be used on one or two MC-5B Servo Controllers Easy to use remote control Large Velcro base for easy, stable surface placement Package includes all required cabling The information contained on this website is subject to change without notice. Critical dimensions or specifications should be verified with our technical support staff.
